Fanuc Alarm 4603: C AXIS SYNCHRONOUS ERROR

Fanuc Alarm 002: TV PARITY ALARM Fanus Control Model: 16i/18i/21i Description When a program is loaded into a CNC machine from a PC, laptop, or an old DNC device, the system checks the number of characters in each line and their order. If the TV Check parameter is turned on and the number of characters…

Fanuc Alarm 5303: TOUCH PANEL ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A touch panel error occurred. Cause;1. The touch panel is kept pressed.;2. The touch panel was pressed when power was turned on. Remove the above causes, and turn on the power again. Have you…

Fanuc Alarm 229: CAN NOT KEEP SYNCHRO–STATE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series;This alarm is generated in the following circumstances.;1 When the synchro/mixed state could not be kept due to system overload.;2 The above condition occurred in CMC devices (hardware) and synchro– state could…

Fanuc Alarm 4703: PROGRAM ERROR (OT –) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The value specified in the Y-axis move command exceeded the negative value of stored stroke limit 1. (Advance check) Have you faced Fanuc Alarm 4703 PROGRAM ERROR (OT –) on your machine? Share your…

Fanuc Alarm 76: ADDRESS P NOT DEFINED Fanuc Control Model: Series 16 / 18 / 21, 16i / 18i / 21i, 0i / 0i-Mate (Series 0i-A/B/C/D/F), 30i / 31i / 32i Model A / B, 21 Model B Fanuc Alarm Description Address P (program number) was not commanded in the block which includes an M98,…

Fanuc Control Model: Fanuc 16i / 18i / 21i Series & 0i / 30i / 31i Series Official Alarm Description The number of tool groups to be set exceeds the maximum allowable value. (See parameter No. 6800 bit 0 and 1) Modify the program Common Causes This alarm is typically triggered when setting up tool…