Fanuc Alarm 4602: ILLEGAL T-CODE
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
The specified T command is not cataloged on the tool register screen.
Have you faced Fanuc Alarm 4602 ILLEGAL T-CODE on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 5228: SAME NAME USED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description There are duplicate file names in the built–in Handy File. Have you faced Fanuc Alarm 5228 SAME NAME USED on your machine? Share your experience or troubleshooting tips in the comments below to help other…
Fanuc Alarm 63: SEQUENCE NUMBER NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;The sequence number specified by address P in G70, G71, G72, or G73 command cannot be searched. Modify the program.
Fanuc Alarm 5155: NOT RESTART PROGRAM BY G05 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description During servo leaning control by G05, an attempt was made to perform restart operation after feed hold or interlock. This restart operation cannot be performed. (G05 leaning control terminates at the same…
Haas Alarm: 184 Z CABLE FAULT Haas Alarm Description Cable from Z-axis encoder does not have valid differential signals. References Haas CNC Alarms and Troubleshooting by official Haas Automation documentation. Have you faced Haas Alarm 184 Z CABLE FAULT on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC…
Fanuc Alarm 226: ILLEGAL COMMAND IN SYNCHRO– MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series (At two–path);A travel command has been sent to the axis being synchronized in synchronous mode. Modify the program or the parameter. Have you faced Fanuc Alarm 226 ILLEGAL COMMAND IN…
Fanuc Alarm 14: ILLEGAL LEAD COMMAND Fanuc Series 0i (0i-TC, 0i-TD, 0i-TF) Fanuc Series 16i / 18i / 21i Fanuc Series 30i / 31i / 32i Description The wrong feed rate and lead limit of the (Threading) process is higher or lower than the limit set in the program, or there is an error in…