Fanuc Alarm 4604: ILLEGAL AXIS OPERATION

Fanuc Alarm 92: AXES NOT ON THE REFERENCE POINT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The commanded axis by G27 (Reference position return check) did not return to the reference position. Have you faced Fanuc Alarm 92 AXES NOT ON THE REFERENCE POINT on your machine?…

Fanuc Alarm 5228: SAME NAME USED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description There are duplicate file names in the built–in Handy File. Have you faced Fanuc Alarm 5228 SAME NAME USED on your machine? Share your experience or troubleshooting tips in the comments below to help other…

Fanuc Alarm 4507: ILLEGAL COMMAND IN SQUARE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a square (G87) command, the tool size (P,Q) was set to zero or a negative value, or the blanking length (I, J) was three times larger than the tool size (P, Q)…

Fanuc Alarm 124: MISSING END STATEMENT Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description DO – END does not correspond to 1: 1. Modify the program. Have you faced Fanuc Alarm 124 MISSING END STATEMENT on your machine? Share your experience or troubleshooting tips in the comments below to help other…

Fanuc Alarm 5114: NOT STOP POSITION (G05.1 Q1) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description At the time of restart after manual intervention, the coordinates at which the manual intervention occurred have not been restored. Have you faced Fanuc Alarm 5114 NOT STOP POSITION (G05.1 Q1) on your…

Fanuc Alarm 100: PARAMETER WRITE ENABLE Fanuc Control Model: Series 16 / 18 / 21 and 16i / 18i / 21i, 30i / 31i / 32i, 15 / 15i Fanuc Alarm Description On the PARAMETER(SETTING) screen, PWE(parameter writing enabled) is set to 1. Set it to 0, then reset the system. Have you faced Fanuc…