Fanuc Alarm 124: MISSING END STATEMENT
Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i and 30i/31i/32i series
DO – END does not correspond to 1: 1. Modify the program.
Have you faced Fanuc Alarm 124 MISSING END STATEMENT on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 0: MISSING MOVE AFTER CHF/CNR Fanuc Control Model: Fanuc 0i, 16i / 18i / 21i, 30i / 31i / 32i Fanuc Alarm 51 (PS0051) is a Program/Software alarm that occurs during Chamfering (CHF) or Corner Rounding (CNR) operations. It triggers when the controller encounters a chamfering/corner rounding block that is not immediately followed…
Fanuc Control Model: Fanuc 16i / 18i / 21i Series & 0i / 30i / 31i Series Official Alarm Description The number of tool groups to be set exceeds the maximum allowable value. (See parameter No. 6800 bit 0 and 1) Modify the program Common Causes This alarm is typically triggered when setting up tool…
Fanuc Alarm 5229: WRITE PROTECTED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A floppy disk in the built–in Handy File is write protected. Have you faced Fanuc Alarm 5229 WRITE PROTECTED on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC…
Fanuc Alarm 5069: WHL–C:ILLEGA P–DATA Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The P data in selection of the grinding–wheel wear compensation center is illegal. Have you faced Fanuc Alarm 5069 WHL–C:ILLEGA P–DATA on your machine? Share your experience or troubleshooting tips in the comments below to help…
Fanuc Alarm 5448: CRC:INTERFERENCE TO AVD. Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In the interference check evade function of cutter compensation, a further interference occurs for an already created interference evade vector. Have you faced Fanuc Alarm 5448 CRC:INTERFERENCE TO AVD. on your machine? Share your experience…
Fanuc Alarm 5110: IMPROPER G–CODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description An illegal G code was specified in look–ahead control mode (multi blocks are read in advance). A command was specified for the index table indexing axis in look– ahead control mode (multi blocks are read…