Fanuc Alarm 5067: (HPCC)

Fanuc Alarm 5407: ILLEGAL COMMAND IN G41.3 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description 1) A G code that belongs to group 01 except G00 and G01 is specified in G41.3 mode.;2) An offset command (a G code belonging to group 07) is specified in G41.3 mode.;3)…

Fanuc Alarm 58: END POINT NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description In an arbitrary angle chamfering or corner R cutting block, a specified axis is not in the selected plane. Correct the program.

Fanuc Alarm 30: ILLEGAL OFFSET NUMBER Fanus Control Model: Series 0/16/18/21/30i/31i/32i Description This alarm occurs when the CNC control is commanded to use a Tool Offset Number that does not exist in the machine’s memory or exceeds the maximum limit defined by your system’s parameters. This problem is usually caused by incorrect use of T-codes…

Fanuc Alarm 5235: COMMUNICATION ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A communication error occurred during communication with the built–in Handy File. Have you faced Fanuc Alarm 5235 COMMUNICATION ERROR on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC…

Fanuc Alarm 5416: NURBS:ILLEGAL MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A mode that cannot be used with NURBS interpolation mode is specified in NURBS interpolation mode. Have you faced Fanuc Alarm 5416 NURBS:ILLEGAL MODE on your machine? Share your experience or troubleshooting tips in the comments…

Fanuc Alarm 5038: TOO MANY START M–CODE COMMAND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series More than six M codes for starting movement about the B–axis were specified. Have you faced Fanuc Alarm 5038 TOO MANY START M–CODE COMMAND on your machine? Share your experience or…