Fanuc Alarm 58: END POINT NOT FOUND
Fanus Control Model: 16/18/21
Fanuc Alarm Description
In an arbitrary angle chamfering or corner R cutting block, a specified axis is not in the selected plane. Correct the program.
Fanuc Alarm 66: IMPROPER G–CODE IN G71–G73 Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;An unallowable G code was commanded between two blocks specified by address P in G71, G72, or G73. Modify the program.
Fanuc Alarm 31: ILLEGAL P COMMAND IN G10 Fanus Control Model: Series 16i / 18i / 21i (Models A and B) and Series 30i / 31i / 32i Description When you use the ‘P’ command incorrectly with a G10 code. The value written after ‘P’ is either outside the offset number that is available in…
Fanuc Alarm 3: TOO MANY DIGITS Fanus Control Model: 16/18/21 Fanuc Alarm Description Data exceeding the maximum allowable number of digits was input. (Refer to the item of max. programmable dimensions.)
Fanuc Alarm 3: Too Many Digits Error Fanus Control Model: Fanuc 0i, 16i/18i, and 21i/31i , 30i/31i/32i/0i-MODEL B Description Entering more digits than allowed in a program. Using non-standard digits in a G-code command for an X, Y, Z position or a speed value. This error usually indicates human error or a problem with the…
Fanuc Alarm 029 (or PS029) ILLEGAL OFFSET VALUE Fanus Control Model: Series 21 / 21i (Model A, B, & C) and modern controls like the 30i / 31i / 32i series Description Any value in the Tool Offset or Work Offset that is outside the specified range of the machine. Fanuc parameters have a limit…
Fanuc Alarm 69: FORMAT ERROR IN G70–G73 Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;The final move command in the blocks specified by P and Q of G70, G71, G72, and G73 ended with chamfering or corner R. Modify the program.