Fanuc Alarm 5073: NO DECIMAL POINT

Fanuc Alarm 410: SERVO ALARM: n–TH AXIS – EXCESS ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The position deviation value when the n–th axis (axis 1–8) stops is larger than the set value. Refer to procedure of trouble shooting. Have you faced Fanuc Alarm 410 SERVO…

Fanuc Alarm 2: TV PARITY ALARM Fanus Control Model: 16/18/21 Fanuc Alarm Description TV alarm (The number of characters in a block is odd). This alarm will be generated only when the TV check is effective.

Fanuc Alarm 4503: ILLEGAL COMMAND IN LINE AT ANGLE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a line-at-angle (G76) command, the number of holes (K) was set to zero or a negative value. Alternatively, I, J, or K was not specified. Have you faced Fanuc Alarm…

Fanuc Alarm 5013: HPCC: CRC OFS REMAIN AT CANCEL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description G05P0 has been specified in G41/G42 mode or with offset remaining Have you faced Fanuc Alarm 5013 HPCC: CRC OFS REMAIN AT CANCEL on your machine? Share your experience or troubleshooting tips…

Fanuc Alarm 5123: OVER TOLERANCE OF END POINT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The difference between a specified end point and the calculated end point exceeds the allowable range (parameter 3471). Have you faced Fanuc Alarm 5123 OVER TOLERANCE OF END POINT on your machine? Share…

Fanuc Alarm 4537: ILLEGAL Q VALUE IN MULTI-PIECE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In the command for taking multiple workpieces (G73, G74), Q is set to a value beyond the range from 1 to 4. Have you faced Fanuc Alarm 4537 ILLEGAL Q VALUE IN…