Fanuc Alarm 5038: TOO MANY START M–CODE COMMAND
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
T series
More than six M codes for starting movement about the B–axis were specified.
Have you faced Fanuc Alarm 5038 TOO MANY START M–CODE COMMAND on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 233: DEVICE BUSY Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description When an attempt was made to use a unit such as that connected via the RS–232–C interface, other users were using it. Have you faced Fanuc Alarm 233 DEVICE BUSY on your machine? Share your experience…
Fanuc Alarm 5009: PARAMETER ZERO Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The maximum feedrate (parameter No. 1422) or the feedrate in dry run (parameter No. 1410) is 0 in the HPCC model. Have you faced Fanuc Alarm 5009 PARAMETER ZERO on your machine? Share your experience or…
Fanuc Alarm 5412: NURBS:NO KNOT COMMAND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description No knot is specified. Alternatively, in NURBS interpolation mode, a block not relating to NURBS interpolation is specified. Have you faced Fanuc Alarm 5412 NURBS:NO KNOT COMMAND on your machine? Share your experience or troubleshooting…
Fanuc Alarm 5411: NURBS:ILLEGAL ORDER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The number of steps is specified incorrectly. Have you faced Fanuc Alarm 5411 NURBS:ILLEGAL ORDER on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear…
Fanuc Alarm 5413: NURBS:ILLEGAL AXIS COMMAND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description An axis not specified with controlled points is specified in the first block. Have you faced Fanuc Alarm 5413 NURBS:ILLEGAL AXIS COMMAND on your machine? Share your experience or troubleshooting tips in the comments below…
Fanuc Alarm 4510: ILLEGAL COMMAND IN LINE-PUNCH Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a linear punching (G45) command, the traveling distance was set to zero or a value 1.5 times larger than the tool size (P) or less. Alternatively, P was not specified. Have you…