Fanuc Alarm 4510: ILLEGAL COMMAND IN LINE-PUNCH

Fanuc Alarm 5452: IMPROPER G–CODE (5AXIS MODE) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A G code that cannot be specified is found. (5–axis mode) This alarm is issued when;1) Three–dimensional cutter compensation (side–face offset and leading– edge offset) is applied during cutter compensation, or cutter compensation…

Fanuc Alarm 28: ILLEGAL PLANE SELECT Fanus Control Model: 16/18/21 Fanuc Alarm Description In the plane selection command, two or more axes in the same direction are commanded. Modify the program.

Fanuc Alarm 4602: ILLEGAL T-CODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The specified T command is not cataloged on the tool register screen. Have you faced Fanuc Alarm 4602 ILLEGAL T-CODE on your machine? Share your experience or troubleshooting tips in the comments below to help other…

Fanuc Alarm 5401: SPL:ILLEGAL COMMAND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a G code mode in which specification of G06.1 is not permitted, G06.1 is specified. Have you faced Fanuc Alarm 5401 SPL:ILLEGAL COMMAND on your machine? Share your experience or troubleshooting tips in the comments…

Fanuc Alarm 63: SEQUENCE NUMBER NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;The sequence number specified by address P in G70, G71, G72, or G73 command cannot be searched. Modify the program.

Fanuc Alarm 233: DEVICE BUSY Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description When an attempt was made to use a unit such as that connected via the RS–232–C interface, other users were using it. Have you faced Fanuc Alarm 233 DEVICE BUSY on your machine? Share your experience…