Fanuc Alarm 5037: ADDRESS Q NOT DEFINED IN G83

Fanuc Alarm 6: ILLEGAL USE OF NEGATIVE SIGN Fanus Control Model: 16/18/21 Fanuc Alarm Description Sign “ – ” input error (Sign “ – ” was input after an address with which it cannot be used. Or two or more “ – ” signs were input.) Modify the program.

Fanuc Control Model: Fanuc 16i / 18i / 21i Series & 0i / 30i / 31i Series Official Alarm Description The number of tool groups to be set exceeds the maximum allowable value. (See parameter No. 6800 bit 0 and 1) Modify the program Common Causes This alarm is typically triggered when setting up tool…

Fanuc Alarm 5409: ILLEGAL PARAMETER IN G41.3 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The parameter setting (No. xxxx to xxxx) that determines the relationship between the rotation axis and rotation plane is incorrect. Have you faced Fanuc Alarm 5409 ILLEGAL PARAMETER IN G41.3 on your machine? Share…

Fanuc Alarm 0: MISSING MOVE AFTER CHF/CNR Fanuc Control Model: Fanuc 0i, 16i / 18i / 21i, 30i / 31i / 32i Fanuc Alarm 51 (PS0051) is a Program/Software alarm that occurs during Chamfering (CHF) or Corner Rounding (CNR) operations. It triggers when the controller encounters a chamfering/corner rounding block that is not immediately followed…

Fanuc Alarm 5039: START UNREGISTERED B–AXS PROG Fanuc Control Model: 0i / 0i-Mate – Model B, 16 / 18 / 21 Fanuc Alarm Description T series An attempt was made to execute a program for the B–axis which had not been registered. Have you faced Fanuc Alarm 5039 START UNREGISTERED B–AXS PROG on your machine? Share…

Fanuc Alarm 252: ATC SPINDLE ALARM Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description An excessive error arose during spindle positioning for ATC. For details, refer to diagnosis No. 531. (Only for ROBODRILL) Have you faced Fanuc Alarm 252 ATC SPINDLE ALARM on your machine? Share your experience or…