Fanuc Alarm 74: ILLEGAL PROGRAM NUMBER

Fanuc Alarm 34: NO CIRC ALLOWED IN ST–UP /EXT BLK Fanus Control Model: Series 0i / 16i / 18i / 21i / 31i / 32i Description This alarm (Fanuc Alarm 34) occurs when you are starting (Start-up block) or ending (Cancel block) Cutter Radius Compensation using G41 or G42, and write Circular Interpolation (G02/G03) instead…

Fanuc Alarm 9: ILLEGAL ADDRESS INPUT Fanus Control Model: 16/18/21 Fanuc Alarm Description Unusable character was input in significant area. Modify the program.

Fanuc Alarm 3: Too Many Digits Error Fanus Control Model: Fanuc 0i, 16i/18i, and 21i/31i , 30i/31i/32i/0i-MODEL B Description Entering more digits than allowed in a program. Using non-standard digits in a G-code command for an X, Y, Z position or a speed value. This error usually indicates human error or a problem with the…

Fanuc Alarm 0: PLEASE TURN OFF POWER Fanus Control Model: 16/18/21 Fanuc Alarm Description A parameter which requires the power off was input, turn off power.

Fanuc Alarm 2: TV PARITY ALARM Fanus Control Model: 16/18/21 Fanuc Alarm Description TV alarm (The number of characters in a block is odd). This alarm will be generated only when the TV check is effective.

Fanuc Alarm 22: NO CIRCULAR RADIUS Fanus Control Model: 16/18/21 Fanuc Alarm Description When circular interpolation is specified, neither R (specifying an arc radius), nor I, J, and K (specifying the distance from a start point to the center) is specified.