Fanuc Alarm 5402: SPL:ILLEGAL AXIS MOVING

Fanuc Alarm 4509: ILLEGAL COMMAND IN CUT AT ANGLE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a cut-at-angle (G89) command, the traveling pitch (Q) was set to zero, negative value, or another value larger than or equal to the length (I). Alternatively, I, J, P, or…

Fanuc Alarm 25: CANNOT COMMAND F0 IN G02/G03 Fanus Control Model: 16/18/21 Fanuc Alarm Description F0 (fast feed) was instructed by F1 –digit column feed in circular interpolation. Modify the program.

Fanuc Alarm 5050: ILL–COMMAND IN CHOPPING MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A command for switching the major axis has been specified for circular threading. Alternatively, a command for setting the length of the major axis to 0 has been specified for circular threading. Have…

Fanuc Alarm 85: COMMUNICATION ERROR Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i, and 30i/31i/32i series Fanuc Alarm Description When entering data in the memory by using Reader / Puncher interface,an overrun, parity or framing error was generated. The number of bits of input data or setting of baud rate or specification No. of I/O unit is…

Fanuc Alarm 233: DEVICE BUSY Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description When an attempt was made to use a unit such as that connected via the RS–232–C interface, other users were using it. Have you faced Fanuc Alarm 233 DEVICE BUSY on your machine? Share your experience…

Fanuc Alarm 5252: ILLEGAL P COMMAND IN G54.2 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The P value specifying the offset number of a fixture offset is too large. Correct the program. Have you faced Fanuc Alarm 5252 ILLEGAL P COMMAND IN G54.2 on your machine? Share your…