Fanuc Alarm 74: ILLEGAL PROGRAM NUMBER

Fanuc Alarm 5038: TOO MANY START M–CODE COMMAND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series More than six M codes for starting movement about the B–axis were specified. Have you faced Fanuc Alarm 5038 TOO MANY START M–CODE COMMAND on your machine? Share your experience or…

Fanuc Alarm 4701: PROGRAM ERROR (OT –) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The value specified in the X-axis move command exceeded the negative value of stored stroke limit 1. (Advance check) Have you faced Fanuc Alarm 4701 PROGRAM ERROR (OT –) on your machine? Share your…

Fanuc Alarm 5010: END OF RECORD Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The end of record (%) was specified. I/O is incorrect. modify the program. Have you faced Fanuc Alarm 5010 END OF RECORD on your machine? Share your experience or troubleshooting tips in the comments below…

Fanuc Alarm 5416: NURBS:ILLEGAL MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A mode that cannot be used with NURBS interpolation mode is specified in NURBS interpolation mode. Have you faced Fanuc Alarm 5416 NURBS:ILLEGAL MODE on your machine? Share your experience or troubleshooting tips in the comments…

Fanuc Alarm PS067: G70–G73 IN FORBIDDEN MODE Fanus Control Model: Most commonly associated with Fanuc Series 0 (0-T/0-TF) and the Series 16/18/21 Description The control system receives a command in G70, G71, G72, or G73 that is incompatible with its specific mode. This problem usually occurs when you run these Canned Cycles in a sub-program…

Fanuc Alarm 4544: MULTI-PIECE RESTART ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In the command for resuming taking multiple workpieces, the resume position (P) is set to a value beyond the range from 1 to total number of workpieces to be machined. Have you faced Fanuc…