Fanuc Alarm 67: CAN NOT ERROR IN MDI MODE

Fanuc Alarm 5445: CRC:MOTION IN G39 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Corner circular interpolation (G39) of cutter compensation is not specified alone but is specified with a move command. Have you faced Fanuc Alarm 5445 CRC:MOTION IN G39 on your machine? Share your experience or troubleshooting…

Fanuc Alarm 5035: NO FEEDRATE COMMANDED B–AXS Fanuc Control Model: 16i / 18i / 21i-T (Model A and Model B), 0i-T / 0i-Mate-T, 16 / 18-T Fanuc Alarm Description T series A feedrate was not specified for cutting feed about the B–axis. Have you faced Fanuc Alarm 5035 NO FEEDRATE COMMANDED B–AXS on your machine? Share…

Fanuc Alarm 60: SEQUENCE NUMBER NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description Commanded sequence number was not found in the sequence number search. Check the sequence number.

Fanuc Alarm 5237: READ ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A floppy disk in the built–in Handy File cannot be read from. The floppy disk may be defective, or the head may be dirty. Alternatively, the Handy File is defective. Have you faced Fanuc Alarm…

Fanuc Alarm 5046: ILLEGAL PARAMETER (ST.COMP) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The parameter settings for straightness compensation contain an error. Possible causes are as follows;1. A parameter for a movement axis or compensation axis contains an axis number which is not used.;2. More than 128…