Fanuc Alarm 5035: NO FEEDRATE COMMANDED B–AXS
Fanuc Control Model: 16i / 18i / 21i-T (Model A and Model B), 0i-T / 0i-Mate-T, 16 / 18-T
T series
A feedrate was not specified for cutting feed about the B–axis.
Have you faced Fanuc Alarm 5035 NO FEEDRATE COMMANDED B–AXS on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm PS006: Illegal Use of Minus Sign Fanus Control Model: Series 0i (Model C, D, and F), Series 30i / 31i / 32i, Series 16i / 18i / 21i Description Minus Sign – is written in a place where it is not allowed. This alarm can sometimes be caused by a logical error in…
Fanuc Alarm 5073: NO DECIMAL POINT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A decimal point is not specified for a command for which a decimal point must be specified. Have you faced Fanuc Alarm 5073 NO DECIMAL POINT on your machine? Share your experience or troubleshooting tips…
Fanuc Alarm 85: COMMUNICATION ERROR Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i, and 30i/31i/32i series Fanuc Alarm Description When entering data in the memory by using Reader / Puncher interface,an overrun, parity or framing error was generated. The number of bits of input data or setting of baud rate or specification No. of I/O unit is…
Fanuc Alarm 5114: NOT STOP POSITION (G05.1 Q1) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description At the time of restart after manual intervention, the coordinates at which the manual intervention occurred have not been restored. Have you faced Fanuc Alarm 5114 NOT STOP POSITION (G05.1 Q1) on your…
Fanuc Alarm 5041: CAN NOT COMMANDED G110 BLOCK Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series;Blocks containing the G110 codes were successively specified in tool– tip radius compensation for the B–axis. Have you faced Fanuc Alarm 5041 CAN NOT COMMANDED G110 BLOCK on your machine? Share your…
Fanuc Alarm 61: ADDRESS P/Q NOT FOUND IN G70–G73 Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;Address P or Q is not specified in G70, G71, G72, or G73 command. Modify the program.