Fanuc Alarm 60: SEQUENCE NUMBER NOT FOUND
Fanuc Alarm 60: SEQUENCE NUMBER NOT FOUND
Fanus Control Model: 16/18/21
Fanuc Alarm Description
Commanded sequence number was not found in the sequence number search. Check the sequence number.
Similar Posts
Fanuc Alarm 233: DEVICE BUSY
Fanuc Alarm 233: DEVICE BUSY Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description When an attempt was made to use a unit such as that connected via the RS–232–C interface, other users were using it. Have you faced Fanuc Alarm 233 DEVICE BUSY on your machine? Share your experience…
Fanuc CNC Alarm 402 Cause and Fix
A Fanuc Alarm 402 is a common but critical error that indicates a Servo Alarm: SV Overload. Essentially, the CNC controller has detected that the electrical current being drawn by a specific axis motor is exceeding its rated capacity for too long. The system triggers this alarm as a protective measure to prevent the motor…
Fanuc Alarm 5134: FSSB: OPEN READY TIME OUT
Fanuc Alarm 5134: FSSB: OPEN READY TIME OUT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Initialization did not place FSSB in the open ready state. Have you faced Fanuc Alarm 5134 FSSB: OPEN READY TIME OUT on your machine? Share your experience or troubleshooting tips in the comments…
Fanuc Alarm 5122: ILLEGAL COMMAND IN SPIRAL
Fanuc Alarm 5122: ILLEGAL COMMAND IN SPIRAL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A spiral interpolation or conical interpolation command has an error. Specifically, this error is caused by one of the following;1) L = 0 is specified.;2) Q = 0 is specified.;3) R/, R/, C…
Fanuc Alarm 94: P TYPE NOT ALLOWED (COORD CHG)
Fanuc Alarm 94: P TYPE NOT ALLOWED (COORD CHG) Fanuc Control Model: Fanuc 16 / 18 / 21, 16i/18i/21i, and 30i/31i/32i series Fanuc Alarm Description P type cannot be specified when the program is restarted. (After the automatic operation was interrupted, the coordinate system setting operation was performed.) Perform the correct operation according to the…
Fanuc Alarm 5115: SPL: ERROR
Fanuc Alarm 5115: SPL: ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description There is an error in the specification of the rank. No knot is specified. The knot specification has an error. The number of axes exceeds the limits. Other program errors Have you faced Fanuc Alarm…