Fanuc Alarm 5219: CAN NOT RETURN
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
Manual intervention or return is not allowed during three–dimensional coordinate conversion.
Have you faced Fanuc Alarm 5219 CAN NOT RETURN on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 0: PLEASE TURN OFF POWER Fanuc Control Model: Series 16 / 18 / 21, 16i / 18i / 21i, 0i Series Fanuc Alarm 0 (PLEASE TURN OFF POWER) is a standard notification alarm that occurs when a parameter requiring a power cycle/reboot is modified on the CNC control. Follow this quick guide to…
Fanuc Alarm 404: SERVO ALARM: n–TH AXIS VRDY ON Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Even though the n–th axis (axis 1–8) READY signal (MCON) went off, the servo amplifier READY signal (DRDY) is still on. Or, when the power was turned on, DRDY went on…
Fanuc Alarm 5447: CRC:DANGEROUS AVOIDANCE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The interference check evade function of cutter compensation determines that an evade operation will lead to danger. Have you faced Fanuc Alarm 5447 CRC:DANGEROUS AVOIDANCE on your machine? Share your experience or troubleshooting tips in the…
Fanuc Alarm PS017 ILLEGAL MODE FOR GOTO/WHILE/DO Fanus Control Model: 10/11/12/15/15i Description This alarm appears when the control system has difficulty executing these macro statements such as GOTO, WHILE, or DO. Does your CNC controller accept these specific commands or is there a fundamental error in the program logic that violates the prevailing rules of…
Fanuc Alarm 4650: IMPROPER G-CODE IN OFFSET MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In the cutter compensation mode, an inhibited G code (pattern command, G73, G74, G75, etc.) was specified. Have you faced Fanuc Alarm 4650 IMPROPER G-CODE IN OFFSET MODE on your machine? Share your…
Fanuc Alarm 5063: IS NOT PRESET AFTER REF. Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Function category: Workpiece thickness measurement Alarm details The position counter was not preset before the start of workpiece thickness measurement. This alarm is issued in the following cases;(1) An attempt has been…