Fanuc Alarm 5111: IMPROPER MODAL G–CODE

Fanuc Alarm 22: NO CIRCULAR RADIUS Fanus Control Model: 16/18/21 Fanuc Alarm Description When circular interpolation is specified, neither R (specifying an arc radius), nor I, J, and K (specifying the distance from a start point to the center) is specified.

Fanuc Alarm 10: Improper G-Code Fanus Control Model: Specific Fanuc model (e.g., Series 0i, 16i, 18i, 21i). Description The machine has received a G-code that it does not recognize or that does not exist in its system. You may have accidentally written an incorrect code, for example, writing G001 or G100 instead of G01, which…

Fanuc Alarm 95: P TYPE NOT ALLOWED (EXT OFS CHG) Fanuc Control Model: Series 0i (0i-A, 0i-B, 0i-C, 0i-D, 0i-F), 16 / 18 / 21 and their i-series variants (16i, 18i, 21i), 30i / 31i / 32i Fanuc Alarm Description P type cannot be specified when the program is restarted.(After the automatic operation was interrupted,…

Fanuc Alarm 251: ATC ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description This alarm is issued in the following cases;– An M06T_ command contains an unusable T code.;– An M06 command has been specified when the Z machine coordi nate is positive.;– The parameter for the current…

Fanuc Alarm 5067: (HPCC) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description HPCC mode cannot be canceled during G51 (scaling) or G68 (coordinate system rotation). Correct the program. Have you faced Fanuc Alarm 5067 (HPCC) on your machine? Share your experience or troubleshooting tips in the comments below to…

Fanuc Alarm 100: PARAMETER WRITE ENABLE Fanuc Control Model: Series 16 / 18 / 21 and 16i / 18i / 21i, 30i / 31i / 32i, 15 / 15i Fanuc Alarm Description On the PARAMETER(SETTING) screen, PWE(parameter writing enabled) is set to 1. Set it to 0, then reset the system. Have you faced Fanuc…