Fanuc Alarm 5014: TRACE DATA NOT FOUND

Fanuc Alarm 3: Too Many Digits Error Fanus Control Model: Fanuc 0i, 16i/18i, and 21i/31i , 30i/31i/32i/0i-MODEL B Description Entering more digits than allowed in a program. Using non-standard digits in a G-code command for an X, Y, Z position or a speed value. This error usually indicates human error or a problem with the…

Fanuc Alarm 5116: SPL: ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description There is a program error in a block under look–ahead control. Monotone increasing of knots is not observed. In NURBS interpolation mode, a mode that cannot be used together is specified. Have you faced Fanuc…

Fanuc Alarm 79: PROGRAM VERIFY ERROR Fanuc Control Model: 0-i, 16/18/21, 16i/18i/21i, 30i/31i/32i Fanuc Alarm Description In memory or program collation, a program in memory does not match the program being verified. Have you faced Fanuc Alarm 79 PROGRAM VERIFY ERROR on your machine? Share your experience or troubleshooting tips in the comments below to help other…

Fanuc Alarm 5012: G05 P10000 ILLEGAL START UP Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Function category: High–precision contour control;Alarm details: G05 P10000 has been specified in a mode from which the system cannot enter HPCC mode. Have you faced Fanuc Alarm 5012 G05 P10000 ILLEGAL START…

Fanuc Alarm 70: NO PROGRAM SPACE IN MEMORY Fanus Control Model: 16/18/21 Fanuc Alarm Description The memory area is insufficient. Delete any unnecessary programs, then retry.

Fanuc Alarm 4508: ILLEGAL COMMAND IN RADIUS Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a radius (G88) command, the traveling pitch (Q) or radius (I) was set to zero or a negative value, or the traveling pitch (Q) was greater than or equal to the arc…