Fanuc Alarm 5198: FSSB: ID DATA NOT READ
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
Temporary assignment failed, so amplifier initial ID information could not be read.
Have you faced Fanuc Alarm 5198 FSSB: ID DATA NOT READ on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 5244: TOO MANY DI ON Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Even when an M code was encountered in automatic operation mode, the flexible synchronization mode signal was not driven on or off. Check the ladder and M codes. Have you faced Fanuc Alarm…
Fanuc Alarm 99: MDI EXEC NOT ALLOWED AFT.SEARCH Fanuc Control Model: Series 0i (Model B, C, D, F), 16i / 18i / 21i, 30i / 31i / 32i Fanuc Alarm Description After completion of search in program restart, a move command is given with MDI. Move axis before a move command or don’t interrupt MDI…
Fanuc Alarm 4540: MULTI-PIECE COMMAND WITHIN MACRO Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The command for taking multiple workpieces (G73, G74) was specified when a U or V macro was being stored. Have you faced Fanuc Alarm 4540 MULTI-PIECE COMMAND WITHIN MACRO on your machine? Share your…
Fanuc Alarm 75: PROTECT Fanuc Control Model: Fanuc 0i, 16i / 18i / 21i, 30i / 31i / 32i Fanuc Alarm 75 (PROTECT) is a memory/program protection alarm that occurs when an operator attempts to edit, insert, or delete a program block or parameter while the Program Protect Key is switched ON or memory write…
Fanuc Alarm 407: SERVO ALARM: EXCESS ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The difference in synchronous axis position deviation exceeded the set value. Have you faced Fanuc Alarm 407 SERVO ALARM: EXCESS ERROR on your machine? Share your experience or troubleshooting tips in the comments below…
Fanuc Alarm PS900: G72.1 NESTING ERROR Fanus Control Model: Series 15i, 16i, 18i, 21i, and 30i/31i/32i Description This alarm appears when the “G72.1” (Subprogram Call for Figure Copy) command is used incorrectly in CNC programming. The main reason for this alarm is exceeding the “Nesting” limit, that is, when you call several subprograms consecutively within…