Fanuc Alarm 99: MDI EXEC NOT ALLOWED AFT.SEARCH

Fanuc Alarm 4524: ILLEGAL COMMAND IN LINE-NIBBL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a linear nibbling (G69) command, the traveling pitch (Q) was set to zero, negative value, or a value larger than or equal to the limit (No. 16186, 16187). Alternatively, I, J, P,…

Fanuc Alarm 4522: EXCESS NIBBLING MOVEMENT (C) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In the circular nibbling (G68) or usual nibbling mode, the C-axis traveling distance was larger than or equal to the limit (No. 16194). Have you faced Fanuc Alarm 4522 EXCESS NIBBLING MOVEMENT (C) on…

A Fanuc Alarm 402 is a common but critical error that indicates a Servo Alarm: SV Overload. Essentially, the CNC controller has detected that the electrical current being drawn by a specific axis motor is exceeding its rated capacity for too long. The system triggers this alarm as a protective measure to prevent the motor…

Fanuc Alarm 58: END POINT NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description In an arbitrary angle chamfering or corner R cutting block, a specified axis is not in the selected plane. Correct the program.

Fanuc Alarm 100: PARAMETER WRITE ENABLE Fanuc Control Model: Series 16 / 18 / 21 and 16i / 18i / 21i, 30i / 31i / 32i, 15 / 15i Fanuc Alarm Description On the PARAMETER(SETTING) screen, PWE(parameter writing enabled) is set to 1. Set it to 0, then reset the system. Have you faced Fanuc…

Fanuc Alarm 4511: ILLEGAL COMMAND IN CIRCLE-PUNCH Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a circular punching (G46, G47) command, the same position was specified for both start and end points of the arc, radius (R) of the arc was set to zero, or the pitch…