Fanuc Alarm PS058: S–COMMAND OUT OF RANGE Fanus Control Model: 0i-D/F series, 16i/18i/21i, and the 30i/31i/32i series. Description If a spindle speed is written in the program that exceeds the machine’s operating capacity, the system will immediately stop the operation and an alarm will appear on the screen. How to Fix Alarm Check the S…
Fanuc Alarm PS123: Missing END Statement Fanus Control Model: Series 0i, 16i, 18i, 21i, and 30i/31i/32i controls Description When you forget to write END at the end of a program using commands like `WHILE` or `IF` in a macro program, the CNC system gets confused and generates an alarm. How to Fix Alarm Go into…
Fanuc Alarm PS449: Illegal Tool Life Data Fanus Control Model: Series 15 (Model A and B), Series 10 / 11 / 12 Description This alarm occurs when there is a technical error in the Tool Life Management data in the machine control system or the specified life limit for a particular tool in the system…
Fanuc Alarm PS900: G72.1 NESTING ERROR Fanus Control Model: Series 15i, 16i, 18i, 21i, and 30i/31i/32i Description This alarm appears when the “G72.1” (Subprogram Call for Figure Copy) command is used incorrectly in CNC programming. The main reason for this alarm is exceeding the “Nesting” limit, that is, when you call several subprograms consecutively within…
Fanuc Alarm PS891: ILLEGAL COMMAND G05 Fanus Control Model: Series 15 control (including Series 15-MA, 15-TA, 15-MF, and 15-TF). Description When the G05 command is written incorrectly in the program or the controller detects a technical error in the use of the G05 command. One reason for this alarm is that the G05 command is…
Fanuc Alarm PS067: G70–G73 IN FORBIDDEN MODE Fanus Control Model: Most commonly associated with Fanuc Series 0 (0-T/0-TF) and the Series 16/18/21 Description The control system receives a command in G70, G71, G72, or G73 that is incompatible with its specific mode. This problem usually occurs when you run these Canned Cycles in a sub-program…
Fanuc Alarm 157: TOO MANY TOOL GROUPS Fanus Control Model: 16i / 18i series, 21 / 21i series Description Each control model has a defined number of tool groups. This alarm is displayed when this number exceeds the machine’s limit. If the programmer does not delete unnecessary tool groups, the control stops the machine’s operation….
Fanuc Alarm PS145: G10.1 TIME OUT Fanus Control Model: Fanuc Series 15 (specifically Model B) and sometimes the Series 10, 11, and 12 control systems. Description When the controller fails to receive a response within the time limit for a specific operation. If the G10.1 command is entered with an incorrect format or illogical values,…
Fanuc Alarm 47: ILLEGAL AXIS SELECT Fanus Control Model: Fanuc Series 16, 18, 21, and the 16i/18i/21i Model C Description when the control system receives a command to move an axis that has not been properly defined, or when there is a conflict in the axis selection logic. How to Fix Alarm To resolve it,…
Fanuc Alarm 110: DATA OVERFLOW Fanus Control Model: 10/11/12 Description This is a fault that usually appears when the controller’s data processing system is overloaded. This alarm indicates that the data you are entering into the machine or the calculation system is performing simultaneously has exceeded its memory or register limits. How to Fix Alarm…