Fanuc Alarm 5196: ILLEGAL OPERATION (HPCC)

Fanuc Alarm 110: DATA OVERFLOW Fanus Control Model: 10/11/12 Description This is a fault that usually appears when the controller’s data processing system is overloaded. This alarm indicates that the data you are entering into the machine or the calculation system is performing simultaneously has exceeded its memory or register limits. How to Fix Alarm…

Fanuc Alarm 5050: ILL–COMMAND IN CHOPPING MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A command for switching the major axis has been specified for circular threading. Alternatively, a command for setting the length of the major axis to 0 has been specified for circular threading. Have…

Fanuc Alarm 5139: FSSB: ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Servo initialization did not terminate normally. The optical cable may be defective, or there may be an error in connection to the amplifier or another module. Check the optical cable and the connection status. Have…

Fanuc Alarm 4543: MULTI-PIECE Q COMMAND ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Although G98P0 was specified, the Q value for the G74 command was not 1 or 3. Although G98K0 was specified, the Q value for the G73 command was not 1 or 2. Have…

Fanuc Alarm 5412: NURBS:NO KNOT COMMAND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description No knot is specified. Alternatively, in NURBS interpolation mode, a block not relating to NURBS interpolation is specified. Have you faced Fanuc Alarm 5412 NURBS:NO KNOT COMMAND on your machine? Share your experience or troubleshooting…

Fanuc Alarm 5044: G68 FORMAT ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series;A G68 command block contains a format error. This alarm is issued in the following cases;1. I, J, or K is missing from a G68 command block (missing coordinate rotation option).;2. I, J,…