Fanuc Alarm 5113: CAN NOT ERROR IN MDI MODE
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
Look–ahead control (multi blocks are read in advance) (G05.1) was specified in MDI mode.
Have you faced Fanuc Alarm 5113 CAN NOT ERROR IN MDI MODE on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 5242: ILLEGAL AXIS NUMBER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The axis number of the synchronous master axis or slave axis is incorrect. (This alarm is issued when flexible synchronization is turned on.) Alternatively, the axis number of the slave axis is smaller than…
Fanuc Alarm 5321: S–COMP. VALUE OVERFLOW Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The straightness compensation value has exceeded the maximum value of 32767.After this alarm is issued, make a manual reference position return. Have you faced Fanuc Alarm 5321 S–COMP. VALUE OVERFLOW on your machine? Share your…
Fanuc Alarm 5031: ILLEGAL COMMAND (G100, G102, G103) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series While a registration start command (G101, G102, or G103) was being executed, another registration start command was specified for the B–axis. Have you faced Fanuc Alarm 5031 ILLEGAL COMMAND (G100,…
Haas Alarm: 183 Y CABLE FAULT – Mill Haas Alarm Description Cable from Y-axis encoder does not have valid differential signals. References Haas CNC Alarms and Troubleshooting by official Haas Automation documentation. Have you faced Haas Alarm 183 Y CABLE FAULT – Mill on your machine? Share your experience or troubleshooting tips in the comments below…
Fanuc Alarm 0: PLEASE TURN OFF POWER Fanuc Control Model: Series 16 / 18 / 21, 16i / 18i / 21i, 0i Series Fanuc Alarm 0 (PLEASE TURN OFF POWER) is a standard notification alarm that occurs when a parameter requiring a power cycle/reboot is modified on the CNC control. Follow this quick guide to…
Fanuc Alarm 404: SERVO ALARM: n–TH AXIS VRDY ON Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Even though the n–th axis (axis 1–8) READY signal (MCON) went off, the servo amplifier READY signal (DRDY) is still on. Or, when the power was turned on, DRDY went on…