Fanuc Alarm 5137: FSSB: CONFIGURATION ERROR
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
FSSB detected a configuration error.
Have you faced Fanuc Alarm 5137 FSSB: CONFIGURATION ERROR on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 4702: PROGRAM ERROR (OT +) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The value specified in the Y-axis move command exceeded the positive value of stored stroke limit 1. (Advance check) Have you faced Fanuc Alarm 4702 PROGRAM ERROR (OT +) on your machine? Share your…
Fanuc Alarm 4500: REPOSITIONING INHIBITED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A repositioning command was specified in the circular interpolation (G02, G03) mode. Have you faced Fanuc Alarm 4500 REPOSITIONING INHIBITED on your machine? Share your experience or troubleshooting tips in the comments below to help other…
Fanuc Alarm 5062: ILLEGAL COMMAND IN G02.3/G03.3 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The value specified in an exponential interpolation command (G02.3/03.3) is illegal. A value that does not allow exponential interpolation is specified. (For example, a negative value is specified in In.) Have you faced…
Fanuc Alarm 415: SERVO ALARM: n–TH AXIS – EXCESS SHIFT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A speed higher than 524288000 units/s was attempted to be set in the n–th axis (axis 1–8). This error occurs as the result of improperly set CMR. Have you faced…
Fanuc Alarm 6: ILLEGAL USE OF NEGATIVE SIGN Fanus Control Model: 16/18/21 Fanuc Alarm Description Sign “ – ” input error (Sign “ – ” was input after an address with which it cannot be used. Or two or more “ – ” signs were input.) Modify the program.
Fanuc Alarm 5435: PARAMETER OUT OF RANGE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Incorrect parameter setting (set value range) Have you faced Fanuc Alarm 5435 PARAMETER OUT OF RANGE on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators…