Fanuc Alarm 4500: REPOSITIONING INHIBITED
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
A repositioning command was specified in the circular interpolation (G02, G03) mode.
Have you faced Fanuc Alarm 4500 REPOSITIONING INHIBITED on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 5303: TOUCH PANEL ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A touch panel error occurred. Cause;1. The touch panel is kept pressed.;2. The touch panel was pressed when power was turned on. Remove the above causes, and turn on the power again. Have you…
Fanuc Alarm 5031: ILLEGAL COMMAND (G100, G102, G103) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series While a registration start command (G101, G102, or G103) was being executed, another registration start command was specified for the B–axis. Have you faced Fanuc Alarm 5031 ILLEGAL COMMAND (G100,…
Fanuc Alarm 5061: ILLEGAL FORMAT IN G02.3/G03.3 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The exponential interpolation command (G02.3/G03.3) has a format error. Address I, J, or K is not specified. The value of address I, J, or K is 0. Have you faced Fanuc Alarm 5061…
Fanuc Alarm 5243: DATA OUT OF RANGE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The gear ratio is not set correctly. (This alarm is issued when flexible synchronization is turned on.) Have you faced Fanuc Alarm 5243 DATA OUT OF RANGE on your machine? Share your experience or…
Fanuc Alarm 5085: SMOOTH IPL ERROR 1 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A block for specifying smooth interpolation contains a syntax error. Have you faced Fanuc Alarm 5085 SMOOTH IPL ERROR 1 on your machine? Share your experience or troubleshooting tips in the comments below to…
Fanuc Alarm 61: ADDRESS P/Q NOT FOUND IN G70–G73 Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;Address P or Q is not specified in G70, G71, G72, or G73 command. Modify the program.