Fanuc Alarm 5138: FSSB: AXIS SETTING NOT COMPLETE

Fanuc Alarm 5136: FSSB: NUMBER OF AMPS IS SMALL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In comparison with the number of controlled axes, the number of amplifiers recognized by FSSB is not enough. Have you faced Fanuc Alarm 5136 FSSB: NUMBER OF AMPS IS SMALL on your…

Fanuc Alarm 5018: POLYGON SPINDLE SPEED ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Function category: Polygon turning;Alarm details: In G51.2 mode, the speed of the spindle or polygon synchronous axis either exceeds the clamp value or is too small. The specified rotation speed ratio thus cannot…

Fanuc Alarm 5037: ADDRESS Q NOT DEFINED IN G83 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series Depth of cut Q was not specified for the G83 code (peck drilling cycle). Alternatively, 0 was specified in Q for the B–axis. Have you faced Fanuc Alarm 5037…

Fanuc Alarm 5242: ILLEGAL AXIS NUMBER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The axis number of the synchronous master axis or slave axis is incorrect. (This alarm is issued when flexible synchronization is turned on.) Alternatively, the axis number of the slave axis is smaller than…

Fanuc Alarm 5245: OTHER AXIS ARE COMMANDED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description One of the following command conditions was present during flexible synchronization or when flexible synchronization was turned on;1. The synchronous master axis or slave axis is the EGB axis.;2. The synchronous master axis…

Fanuc Alarm PS058: S–COMMAND OUT OF RANGE Fanus Control Model: 0i-D/F series, 16i/18i/21i, and the 30i/31i/32i series. Description If a spindle speed is written in the program that exceeds the machine’s operating capacity, the system will immediately stop the operation and an alarm will appear on the screen. How to Fix Alarm Check the S…