Fanuc Alarm 5: NO DATA AFTER ADDRESS

Fanuc Alarm 5009: PARAMETER ZERO Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The maximum feedrate (parameter No. 1422) or the feedrate in dry run (parameter No. 1410) is 0 in the HPCC model. Have you faced Fanuc Alarm 5009 PARAMETER ZERO on your machine? Share your experience or…

Fanuc Alarm 413: SERVO ALARM: n–th AXIS – LSI OVERFLOW Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The contents of the error register for the n–th axis (axis 1–8) exceeded ±231 power. This error usually occurs as the result of an improperly set parameters. Have you faced…

Fanuc Alarm 5118: SPL: ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description After manual intervention with manual absolute mode set to on, NURBS interpolation was restarted. Have you faced Fanuc Alarm 5118 SPL: ERROR on your machine? Share your experience or troubleshooting tips in the comments below to…

Fanuc Alarm 118: PARENTHESIS NESTING ERROR Fanus Control Model: 16/18/21 Fanuc Alarm Description The nesting level of brackets or parentheses in a macro expression exceeds the limit of 5 levels.

Fanuc Alarm 5413: NURBS:ILLEGAL AXIS COMMAND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description An axis not specified with controlled points is specified in the first block. Have you faced Fanuc Alarm 5413 NURBS:ILLEGAL AXIS COMMAND on your machine? Share your experience or troubleshooting tips in the comments below…

Fanuc Alarm 4506: ILLEGAL COMMAND IN SHARE PROOFS Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a shear proof (G86) command, the tool size (P) was set to zero, or the blanking length (I) was 1.5 times larger than the tool size (P) or less. Alternatively, I,…