Fanuc Alarm 5446: CRC:NO AVOIDANCE

Fanuc Alarm 4532: IMPROPER U/V MACRO NUMBER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The number of an inhibited macro (number beyond the range from 01 to 99) was specified in a U or V macro command. Have you faced Fanuc Alarm 4532 IMPROPER U/V MACRO NUMBER on…

Fanuc Alarm 5415: NURBS:ILLEGAL CANCEL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Although NURBS interpolation is not completed yet, the NURBS interpolation mode is turned off. Have you faced Fanuc Alarm 5415 NURBS:ILLEGAL CANCEL on your machine? Share your experience or troubleshooting tips in the comments below to…

Fanuc Alarm 5034: PLURAL COMMAND IN G110 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series Multiple movements were specified with the G110 code for the B–axis. Have you faced Fanuc Alarm 5034 PLURAL COMMAND IN G110 on your machine? Share your experience or troubleshooting tips in the…

Fanuc Alarm 5237: READ ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A floppy disk in the built–in Handy File cannot be read from. The floppy disk may be defective, or the head may be dirty. Alternatively, the Handy File is defective. Have you faced Fanuc Alarm…

Fanuc Alarm 5112: G08 CAN NOT BE COMMANDED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series;Look–ahead control (G08) was specified in look–ahead control mode (multi blocks are read in advance). Have you faced Fanuc Alarm 5112 G08 CAN NOT BE COMMANDED on your machine? Share your experience…

Fanuc Alarm 036 (or P/S 36): CAN NOT COMMANDED G31 Fanus Control Model: Series 16/18/21 Description This alarm occurs when a skip cutting command (G31) is called while the machine is actively using cutter compensation (G41 or G42) or tool nose radius compensation. How to Fix Alarm Cancel cutter compensation by writing G40 before issuing…