Fanuc Alarm 5053: M–NET CONNECT ERROR

Fanuc Alarm 3: TOO MANY DIGITS Fanus Control Model: 16/18/21 Fanuc Alarm Description Data exceeding the maximum allowable number of digits was input. (Refer to the item of max. programmable dimensions.)

Fanuc Alarm 5085: SMOOTH IPL ERROR 1 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A block for specifying smooth interpolation contains a syntax error. Have you faced Fanuc Alarm 5085 SMOOTH IPL ERROR 1 on your machine? Share your experience or troubleshooting tips in the comments below to…

Fanuc Alarm 5009: PARAMETER ZERO Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The maximum feedrate (parameter No. 1422) or the feedrate in dry run (parameter No. 1410) is 0 in the HPCC model. Have you faced Fanuc Alarm 5009 PARAMETER ZERO on your machine? Share your experience or…

Fanuc Alarm 231: ILLEGAL FORMAT IN G10 OR L50 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Any of the following errors occurred in the specified format at the programmable– parameter input.;1 Address N or R was not entered.;2 A number not specified for a parameter was entered.;3…

Fanuc Alarm 5124: CAN NOT COMMAND SPIRAL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A spiral interpolation or conical interpolation was specified in any of the following modes;1) Scaling;2) Programmable mirror image;3) Polar coordinate interpolation In cutter compensation C mode, the center is set as the start…

Fanuc Alarm 22: NO CIRCULAR RADIUS Fanus Control Model: 16/18/21 Fanuc Alarm Description When circular interpolation is specified, neither R (specifying an arc radius), nor I, J, and K (specifying the distance from a start point to the center) is specified.