Fanuc Alarm 4534: W MACRO NUMBER NOT FOUND
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
Macro number W specified in a U or V macro command is not stored.
Have you faced Fanuc Alarm 4534 W MACRO NUMBER NOT FOUND on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 403: SERVO ALARM: CARD/SOFT MISMATCH Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The combination of the axis control card and servo software is illegal. Have you faced Fanuc Alarm 403 SERVO ALARM: CARD/SOFT MISMATCH on your machine? Share your experience or troubleshooting tips in the comments…
Fanuc Alarm 5156: ILLEGAL AXIS OPERATION Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In look–ahead control mode (multi blocks are read in advance), the controlled axis selection signal (PMC axis control) changes. In look–achead control mode (multi blocks are read in advance), the simple synchronous axis selection…
Fanuc Alarm 85: COMMUNICATION ERROR Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i, and 30i/31i/32i series Fanuc Alarm Description When entering data in the memory by using Reader / Puncher interface,an overrun, parity or framing error was generated. The number of bits of input data or setting of baud rate or specification No. of I/O unit is…
Fanuc Alarm 5: NO DATA AFTER ADDRESS Fanus Control Model: 16/18/21 Fanuc Alarm Description The address was not followed by the appropriate data but was followed by another address or EOB code. Modify the program.
Fanuc Alarm 5414: NURBS:ILLEGAL KNOT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The number of blocks containing knots only is insufficient. Have you faced Fanuc Alarm 5414 NURBS:ILLEGAL KNOT on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and…
Fanuc Alarm 231: ILLEGAL FORMAT IN G10 OR L50 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Any of the following errors occurred in the specified format at the programmable– parameter input.;1 Address N or R was not entered.;2 A number not specified for a parameter was entered.;3…