Fanuc Alarm 23: ILLEGAL RADIUS COMMAND

Fanuc CNC Alarm 33: NO SOLUTION AT CRC Fanus Control Model: Series 16 / 18 / 21 (M and T Series) Description During tool radius compensation (G41/G42), the intersection point of two geometric lines or arcs fails to be detected. How to Fix Alarm Correct the tool path in the G-code program, or go to…

Fanuc Alarm 25: CANNOT COMMAND F0 IN G02/G03 Fanus Control Model: 16/18/21 Fanuc Alarm Description F0 (fast feed) was instructed by F1 –digit column feed in circular interpolation. Modify the program.

Fanuc Alarm PS017 ILLEGAL MODE FOR GOTO/WHILE/DO Fanus Control Model: 10/11/12/15/15i Description This alarm appears when the control system has difficulty executing these macro statements such as GOTO, WHILE, or DO. Does your CNC controller accept these specific commands or is there a fundamental error in the program logic that violates the prevailing rules of…

Fanuc Alarm 34: NO CIRC ALLOWED IN ST–UP /EXT BLK Fanus Control Model: Series 0i / 16i / 18i / 21i / 31i / 32i Description This alarm (Fanuc Alarm 34) occurs when you are starting (Start-up block) or ending (Cancel block) Cutter Radius Compensation using G41 or G42, and write Circular Interpolation (G02/G03) instead…

Fanuc Alarm 58: END POINT NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description In an arbitrary angle chamfering or corner R cutting block, a specified axis is not in the selected plane. Correct the program.

Fanuc Alarm 101: PLEASE CLEAR MEMORY Fanus Control Model: Series 0, 16, 18, 21 Description When the power is turned off or the controller suddenly shuts down while writing data to memory (such as loading or editing a program), the part of the memory where the data was stored becomes “corrupted.” How to Fix Alarm…