Fanuc Alarm 5432: G02.4/G03.4 FORMAT ERROR

Fanuc Alarm 5111: IMPROPER MODAL G–CODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series;An illegal G code is left modal when look–ahead control mode was specified. Have you faced Fanuc Alarm 5111 IMPROPER MODAL G–CODE on your machine? Share your experience or troubleshooting tips in the comments…

Fanuc Alarm PS017 ILLEGAL MODE FOR GOTO/WHILE/DO Fanus Control Model: 10/11/12/15/15i Description This alarm appears when the control system has difficulty executing these macro statements such as GOTO, WHILE, or DO. Does your CNC controller accept these specific commands or is there a fundamental error in the program logic that violates the prevailing rules of…

Fanuc Alarm 5135: FSSB: ERROR MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description FSSB has entered error mode. Have you faced Fanuc Alarm 5135 FSSB: ERROR MODE on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear…

Fanuc Alarm 118: PARENTHESIS NESTING ERROR Fanus Control Model: 16/18/21 Fanuc Alarm Description The nesting level of brackets or parentheses in a macro expression exceeds the limit of 5 levels.

Fanuc Alarm 5243: DATA OUT OF RANGE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The gear ratio is not set correctly. (This alarm is issued when flexible synchronization is turned on.) Have you faced Fanuc Alarm 5243 DATA OUT OF RANGE on your machine? Share your experience or…

Fanuc Alarm 5040: CAN NOT COMMANDED B–AXS MOVE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series;The machine could not move about the B–axis because parameter No.8250 was incorrectly specified, or because the PMC axis system could not be used. Have you faced Fanuc Alarm 5040 CAN…