Fanuc Alarm 5228: SAME NAME USED

Fanuc Alarm 58: END POINT NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description In an arbitrary angle chamfering or corner R cutting block, a specified axis is not in the selected plane. Correct the program.

Fanuc Alarm 5445: CRC:MOTION IN G39 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Corner circular interpolation (G39) of cutter compensation is not specified alone but is specified with a move command. Have you faced Fanuc Alarm 5445 CRC:MOTION IN G39 on your machine? Share your experience or troubleshooting…

Fanuc Alarm 23: ILLEGAL RADIUS COMMAND Fanus Control Model: 16/18/21 Fanuc Alarm Description (T series) In circular interpolation by radius designation, negative value was commanded for address R. Modify the program.

Fanuc Alarm 4536: NO W, Q COMMAND IN MULTI-PIECE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description W or Q was not specified in the command for taking multiple workpieces (G73, G74). Have you faced Fanuc Alarm 4536 NO W, Q COMMAND IN MULTI-PIECE on your machine? Share your…

Fanuc Alarm 4630: ILLEGAL COMMAND IN LASER MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In the laser mode, a nibbling command or pattern command was specified. In the tracing mode, an attempt was made to make a switch to the punching mode. Have you faced Fanuc…

Fanuc Alarm 15: TOO MANY AXES COMMANDED Fanus Control Model: Fanuc Series 0/0i, 16i, 18i, 21i, 31i, and newer models Description This alarm typically occurs during a block of CNC code when the system attempts to move or command more axes than it is currently configured to handle simultaneously. This is often a programming logic…