Fanuc Alarm 5136: FSSB: NUMBER OF AMPS IS SMALL

Fanuc Alarm 244: P/S ALARM Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series;In the skip function activated by the torque limit signal, the number of accumulated erroneous pulses exceed 32767 before the signal was input. Therefore, the pulses cannot be corrected with one distribution. Change the…

Fanuc Alarm 4534: W MACRO NUMBER NOT FOUND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Macro number W specified in a U or V macro command is not stored. Have you faced Fanuc Alarm 4534 W MACRO NUMBER NOT FOUND on your machine? Share your experience or troubleshooting…

Fanuc Alarm 5222: SRAM CORRECTABLE ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The SRAM correctable error cannot be corrected. Cause: A memory problem occurred during memory initialization. Action: Replace the master printed circuit board (SRAM module). Have you faced Fanuc Alarm 5222 SRAM CORRECTABLE ERROR on your…

Fanuc Alarm 66: IMPROPER G–CODE IN G71–G73 Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;An unallowable G code was commanded between two blocks specified by address P in G71, G72, or G73. Modify the program.

Fanuc Alarm 5010: END OF RECORD Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The end of record (%) was specified. I/O is incorrect. modify the program. Have you faced Fanuc Alarm 5010 END OF RECORD on your machine? Share your experience or troubleshooting tips in the comments below…

Fanuc Alarm 5227: FILE NOT FOUND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A specified file is not found during communication with the built–in Handy File. Have you faced Fanuc Alarm 5227 FILE NOT FOUND on your machine? Share your experience or troubleshooting tips in the comments below…