Fanuc Alarm 5134: FSSB: OPEN READY TIME OUT

Fanuc Alarm 3: Too Many Digits Error Fanus Control Model: Fanuc 0i, 16i/18i, and 21i/31i , 30i/31i/32i/0i-MODEL B Description Entering more digits than allowed in a program. Using non-standard digits in a G-code command for an X, Y, Z position or a speed value. This error usually indicates human error or a problem with the…

Fanuc Alarm 109: FORMAT ERROR IN G08 Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i, and 30i/31i/32i series Fanuc Alarm Description A value other than 0 or 1 was specified after P in the G08 code, or no value was specified. Have you faced Fanuc Alarm 109 FORMAT ERROR IN G08 on your machine? Share your experience…

Fanuc Alarm 31: ILLEGAL P COMMAND IN G10 Fanus Control Model: Series 16i / 18i / 21i (Models A and B) and Series 30i / 31i / 32i Description When you use the ‘P’ command incorrectly with a G10 code. The value written after ‘P’ is either outside the offset number that is available in…

Fanuc Alarm 4524: ILLEGAL COMMAND IN LINE-NIBBL Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a linear nibbling (G69) command, the traveling pitch (Q) was set to zero, negative value, or a value larger than or equal to the limit (No. 16186, 16187). Alternatively, I, J, P,…

Fanuc Alarm 5014: TRACE DATA NOT FOUND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series;Transfer cannot be performed because no trace data exists. Have you faced Fanuc Alarm 5014 TRACE DATA NOT FOUND on your machine? Share your experience or troubleshooting tips in the comments below to…

Fanuc Alarm 220: ILLEGAL COMMAND IN SYNCHR–MODE Fanuc Control Model: Series 0i-T, 16i/18i/21i-T, and 30i/31i/32i-T Fanuc Alarm Description T series In the synchronous operation, movement is commanded by the NC program or PMC axis control interface for the synchronous axis. Have you faced Fanuc Alarm 220 ILLEGAL COMMAND IN SYNCHR–MODE on your machine? Share your experience…