Fanuc Alarm 5074: ADDRESS DUPLICATION ERROR

Fanuc Alarm 4534: W MACRO NUMBER NOT FOUND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Macro number W specified in a U or V macro command is not stored. Have you faced Fanuc Alarm 4534 W MACRO NUMBER NOT FOUND on your machine? Share your experience or troubleshooting…

Fanuc Alarm 5436: PARAMETER SETTING ERROR 1 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Incorrect parameter setting (setting of the rotation axis) Have you faced Fanuc Alarm 5436 PARAMETER SETTING ERROR 1 on your machine? Share your experience or troubleshooting tips in the comments below to help other…

Fanuc Alarm 5448: CRC:INTERFERENCE TO AVD. Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In the interference check evade function of cutter compensation, a further interference occurs for an already created interference evade vector. Have you faced Fanuc Alarm 5448 CRC:INTERFERENCE TO AVD. on your machine? Share your experience…

Fanuc Alarm 4502: ILLEGAL COMMAND IN BOLT HOLE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a bolt hole circle (G26) command, the radius (I) was set to zero or a negative value, or the number of holes (K) was set to zero. Alternatively, I, J, or…

Fanuc Alarm 58: END POINT NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description In an arbitrary angle chamfering or corner R cutting block, a specified axis is not in the selected plane. Correct the program.

Fanuc Alarm 48: BASIC 3 AXIS NOT FOUND Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description For startup of three–dimensional tool compensation or three–dimensional coordinate conversion, the three basic axes used when Xp,Yp and Zp are omitted were not specified in parameter No. 1022. Have you faced Fanuc Alarm 48 BASIC…