Fanuc Alarm 5039: START UNREGISTERED B–AXS PROG
Fanuc Control Model: 0i / 0i-Mate – Model B, 16 / 18 / 21
T series
An attempt was made to execute a program for the B–axis which had not been registered.
Have you faced Fanuc Alarm 5039 START UNREGISTERED B–AXS PROG on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 5031: ILLEGAL COMMAND (G100, G102, G103) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series While a registration start command (G101, G102, or G103) was being executed, another registration start command was specified for the B–axis. Have you faced Fanuc Alarm 5031 ILLEGAL COMMAND (G100,…
Fanuc Alarm 5413: NURBS:ILLEGAL AXIS COMMAND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description An axis not specified with controlled points is specified in the first block. Have you faced Fanuc Alarm 5413 NURBS:ILLEGAL AXIS COMMAND on your machine? Share your experience or troubleshooting tips in the comments below…
Fanuc Alarm 5063: IS NOT PRESET AFTER REF. Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Function category: Workpiece thickness measurement Alarm details The position counter was not preset before the start of workpiece thickness measurement. This alarm is issued in the following cases;(1) An attempt has been…
Fanuc Alarm 401: SERVO ALARM: n–TH AXIS VRDY OFF Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The n–th axis (axis 1–8) servo amplifier READY signal (DRDY) went off. Refer to procedure of trouble shooting. Have you faced Fanuc Alarm 401 SERVO ALARM: n–TH AXIS VRDY OFF on your…
Fanuc Control Model: Fanuc 16i / 18i / 21i Series & 0i / 30i / 31i Series Official Alarm Description The number of tool groups to be set exceeds the maximum allowable value. (See parameter No. 6800 bit 0 and 1) Modify the program Common Causes This alarm is typically triggered when setting up tool…
Fanuc Alarm 229: CAN NOT KEEP SYNCHRO–STATE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series;This alarm is generated in the following circumstances.;1 When the synchro/mixed state could not be kept due to system overload.;2 The above condition occurred in CMC devices (hardware) and synchro– state could…