Fanuc Alarm 4504: ILLEGAL COMMAND IN ARC

Fanuc Alarm 5220: REFERENCE POINT ADJUSTMENT MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A parameter for automatically set a reference position is set. (Bit 2 of parameter No. 1819 = 1) Perform automatic setting. (Position the machine at the reference position manually, then perform manual reference…

Fanuc Alarm 5009: PARAMETER ZERO Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The maximum feedrate (parameter No. 1422) or the feedrate in dry run (parameter No. 1410) is 0 in the HPCC model. Have you faced Fanuc Alarm 5009 PARAMETER ZERO on your machine? Share your experience or…

Fanuc Alarm 5058: G35/G36 FORMAT ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A command for switching the major axis has been specified for circular threading. Alternatively, a command for setting the length of the major axis to 0 has been specified for circular threading. Have you…

Fanuc Alarm 4502: ILLEGAL COMMAND IN BOLT HOLE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a bolt hole circle (G26) command, the radius (I) was set to zero or a negative value, or the number of holes (K) was set to zero. Alternatively, I, J, or…

Fanuc Alarm 5231: TOO MANY FILES Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The number of files exceeds the limit during communication with the built–in Handy File. Have you faced Fanuc Alarm 5231 TOO MANY FILES on your machine? Share your experience or troubleshooting tips in the comments…

Fanuc Alarm 5300: SET ALL OFFSET DATAS AGAIN Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description After the inch/metric automatic conversion function (OIM: Bit 0 of parameter No. 5006) for tool offset data is enabled or disabled, all the tool offset data must be reset. This message reminds…