Fanuc Alarm 25: CANNOT COMMAND F0 IN G02/G03

Fanuc Alarm 23: ILLEGAL RADIUS COMMAND Fanus Control Model: 16/18/21 Fanuc Alarm Description (T series) In circular interpolation by radius designation, negative value was commanded for address R. Modify the program.

Fanuc Alarm 3: Too Many Digits Error Fanus Control Model: Fanuc 0i, 16i/18i, and 21i/31i , 30i/31i/32i/0i-MODEL B Description Entering more digits than allowed in a program. Using non-standard digits in a G-code command for an X, Y, Z position or a speed value. This error usually indicates human error or a problem with the…

Fanuc Alarm PS006: Illegal Use of Minus Sign Fanus Control Model: Series 0i (Model C, D, and F), Series 30i / 31i / 32i, Series 16i / 18i / 21i Description Minus Sign – is written in a place where it is not allowed. This alarm can sometimes be caused by a logical error in…

Fanuc Alarm 34: NO CIRC ALLOWED IN ST–UP /EXT BLK Fanus Control Model: Series 0i / 16i / 18i / 21i / 31i / 32i Description This alarm (Fanuc Alarm 34) occurs when you are starting (Start-up block) or ending (Cancel block) Cutter Radius Compensation using G41 or G42, and write Circular Interpolation (G02/G03) instead…

Fanuc Alarm 73: PROGRAM NUMBER ALREADY IN USE Fanus Control Model: 16/18/21 Fanuc Alarm Description The commanded program number has already been used. Change the program number or delete unnecessary programs and execute program registration again.

Fanuc Alarm 20: OVER TOLERANCE OF RADIUS Fanus Control Model: 16/18/21 Fanuc Alarm Description In circular interpolation (G02 or G03), difference of the distance between the start point and the center of an arc and that between the end point and the center of the arc exceeded the value specified in parameter No. 3410.