Fanuc Alarm 22: NO CIRCULAR RADIUS

Fanuc Alarm 73: PROGRAM NUMBER ALREADY IN USE Fanus Control Model: 16/18/21 Fanuc Alarm Description The commanded program number has already been used. Change the program number or delete unnecessary programs and execute program registration again.

Fanuc Alarm PS067: G70–G73 IN FORBIDDEN MODE Fanus Control Model: Most commonly associated with Fanuc Series 0 (0-T/0-TF) and the Series 16/18/21 Description The control system receives a command in G70, G71, G72, or G73 that is incompatible with its specific mode. This problem usually occurs when you run these Canned Cycles in a sub-program…

Fanuc Alarm 86: DR SIGNAL OFF Fanus Control Model: Fanuc 16, 18, and 21 Series (including i-series), Fanuc 0/0i Series (0-M, 0-T, 0i-MA, 0i-TB, 0i-MC, etc.) Description This simply means that the controller is not receiving a “Data Set Ready” (DSR) signal from the external device PC or laptop. This problem mostly occurs when you…

Fanuc Alarm 64: SHAPE PROGRAM NOT MONOTONOUSLY Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;A target shape which cannot be made by monotonic machining was specified in a repetitive canned cycle (G71 or G72).

Fanuc Alarm 63: SEQUENCE NUMBER NOT FOUND Fanus Control Model: 16/18/21 Fanuc Alarm Description T Series;The sequence number specified by address P in G70, G71, G72, or G73 command cannot be searched. Modify the program.

Fanuc Alarm 1: TH PARITY ALARM Fanus Control Model: 16/18/21 Fanuc Alarm Description TH alarm (A character with incorrect parity was input). Correct the tape.