Fanuc Alarm 5064: DIFFERRENT AXIS UNIT (IS–B, IS–C)

Fanuc Alarm 95: P TYPE NOT ALLOWED (EXT OFS CHG) Fanuc Control Model: Series 0i (0i-A, 0i-B, 0i-C, 0i-D, 0i-F), 16 / 18 / 21 and their i-series variants (16i, 18i, 21i), 30i / 31i / 32i Fanuc Alarm Description P type cannot be specified when the program is restarted.(After the automatic operation was interrupted,…

Fanuc Alarm 5198: FSSB: ID DATA NOT READ Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Temporary assignment failed, so amplifier initial ID information could not be read. Have you faced Fanuc Alarm 5198 FSSB: ID DATA NOT READ on your machine? Share your experience or troubleshooting tips in…

Fanuc Alarm 5009: PARAMETER ZERO Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The maximum feedrate (parameter No. 1422) or the feedrate in dry run (parameter No. 1410) is 0 in the HPCC model. Have you faced Fanuc Alarm 5009 PARAMETER ZERO on your machine? Share your experience or…

Fanuc Alarm 5063: IS NOT PRESET AFTER REF. Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Function category: Workpiece thickness measurement Alarm details The position counter was not preset before the start of workpiece thickness measurement. This alarm is issued in the following cases;(1) An attempt has been…

Fanuc Alarm 5085: SMOOTH IPL ERROR 1 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A block for specifying smooth interpolation contains a syntax error. Have you faced Fanuc Alarm 5085 SMOOTH IPL ERROR 1 on your machine? Share your experience or troubleshooting tips in the comments below to…

Fanuc Alarm 5032: NEW PRG REGISTERED IN B–AXS MOVE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series While the machine was moving about the B–axis, at attempt was made to register another move command. Have you faced Fanuc Alarm 5032 NEW PRG REGISTERED IN B–AXS MOVE on…