Fanuc Alarm 5003: ILLEGAL PARAMETER
Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series
There is an invalid parameter.
Have you faced Fanuc Alarm 5003 ILLEGAL PARAMETER on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error faster!
Fanuc Alarm 401: SERVO ALARM: n–TH AXIS VRDY OFF Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The n–th axis (axis 1–8) servo amplifier READY signal (DRDY) went off. Refer to procedure of trouble shooting. Have you faced Fanuc Alarm 401 SERVO ALARM: n–TH AXIS VRDY OFF on your…
Fanuc Alarm 5251: ILLEGAL PARAMETER IN G54.2 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A fixture offset parameter (No. 7580 to 7588) is illegal. Correct the parameter. Have you faced Fanuc Alarm 5251 ILLEGAL PARAMETER IN G54.2 on your machine? Share your experience or troubleshooting tips in the…
Fanuc Alarm 226: ILLEGAL COMMAND IN SYNCHRO– MODE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series (At two–path);A travel command has been sent to the axis being synchronized in synchronous mode. Modify the program or the parameter. Have you faced Fanuc Alarm 226 ILLEGAL COMMAND IN…
Fanuc Alarm 5417: NURBS:ILLEGAL MULTI–KNOT Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description As many knots as the number of steps are not specified at the start and end points. Have you faced Fanuc Alarm 5417 NURBS:ILLEGAL MULTI–KNOT on your machine? Share your experience or troubleshooting tips in the…
Fanuc Alarm 5242: ILLEGAL AXIS NUMBER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The axis number of the synchronous master axis or slave axis is incorrect. (This alarm is issued when flexible synchronization is turned on.) Alternatively, the axis number of the slave axis is smaller than…
Fanuc Alarm 80: G37 ARRIVAL SIGNAL NOT ASSERTED Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series In the automatic tool length measurement function (G37), the measurement position reach signal (XAE, YAE,or ZAE) is not turned on within an area specified in parameter 6254 (value ε).This is due to a…