Fanuc Alarm 402: SERVO ALARM: SV CARD NOT EXIST

Fanuc Alarm 229: CAN NOT KEEP SYNCHRO–STATE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series;This alarm is generated in the following circumstances.;1 When the synchro/mixed state could not be kept due to system overload.;2 The above condition occurred in CMC devices (hardware) and synchro– state could…

Fanuc Alarm 71: DATA NOT FOUND Fanuc Control Model: Series 0 / 0-Mate / 0i (Model A, B, C, D, F), 16 / 18 / 21 and 16i / 18i / 21i, 160i / 180i / 210i, 30i / 31i / 32i Fanuc Alarm Description The address to be searched was not found. Or the…

Fanuc Alarm 30: ILLEGAL OFFSET NUMBER Fanus Control Model: Series 0/16/18/21/30i/31i/32i Description This alarm occurs when the CNC control is commanded to use a Tool Offset Number that does not exist in the machine’s memory or exceeds the maximum limit defined by your system’s parameters. This problem is usually caused by incorrect use of T-codes…

Fanuc Alarm 4505: ILLEGAL COMMAND IN GRID Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a grid (G78, G79) command, the number of holes (P, K) was set to zero or a negative value. Alternatively, I, J, K, or P was not specified. Have you faced Fanuc…

Fanuc Alarm 218: NOT FOUND P/Q COMMAND IN G251 (T series) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm 218 is a Program/Software (P/S) alarm designated specifically for T series (Turning/Lathe) CNC control models. Fanuc Alarm Description T series P or Q is not commanded in the G251 block,…

Fanuc Alarm 4703: PROGRAM ERROR (OT –) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The value specified in the Y-axis move command exceeded the negative value of stored stroke limit 1. (Advance check) Have you faced Fanuc Alarm 4703 PROGRAM ERROR (OT –) on your machine? Share your…