Fanuc Alarm 5447: CRC:DANGEROUS AVOIDANCE

Fanuc Alarm 14: ILLEGAL LEAD COMMAND Fanuc Series 0i (0i-TC, 0i-TD, 0i-TF) Fanuc Series 16i / 18i / 21i Fanuc Series 30i / 31i / 32i Description The wrong feed rate and lead limit of the (Threading) process is higher or lower than the limit set in the program, or there is an error in…

Fanuc Alarm 5014: TRACE DATA NOT FOUND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series;Transfer cannot be performed because no trace data exists. Have you faced Fanuc Alarm 5014 TRACE DATA NOT FOUND on your machine? Share your experience or troubleshooting tips in the comments below to…

Fanuc Alarm PS006: Illegal Use of Minus Sign Fanus Control Model: Series 0i (Model C, D, and F), Series 30i / 31i / 32i, Series 16i / 18i / 21i Description Minus Sign – is written in a place where it is not allowed. This alarm can sometimes be caused by a logical error in…

Fanuc Control Model: Fanuc 16i / 18i / 21i Series & 0i / 30i / 31i Series Official Alarm Description The number of tool groups to be set exceeds the maximum allowable value. (See parameter No. 6800 bit 0 and 1) Modify the program Common Causes This alarm is typically triggered when setting up tool…

Fanuc Alarm 4705: PROGRAM ERROR (OT –) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The value specified in the Z-axis move command exceeded the negative value of stored stroke limit 1. (Advance check) Have you faced Fanuc Alarm 4705 PROGRAM ERROR (OT –) on your machine? Share your…