Fanuc Alarm 5414: NURBS:ILLEGAL KNOT

Fanuc Alarm 5003: ILLEGAL PARAMETER Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description There is an invalid parameter. Have you faced Fanuc Alarm 5003 ILLEGAL PARAMETER on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear this error…

Fanuc Alarm 4507: ILLEGAL COMMAND IN SQUARE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a square (G87) command, the tool size (P,Q) was set to zero or a negative value, or the blanking length (I, J) was three times larger than the tool size (P, Q)…

Fanuc Alarm 11: NO FEEDRATE COMMANDED Fanus Control Model: 16/18/21 Fanuc Alarm Description Feedrate was not commanded to a cutting feed or the feedrate was inadequate. Modify the program.

Fanuc Alarm 74: ILLEGAL PROGRAM NUMBER Fanus Control Model: 16/18/21 Fanuc Alarm Description The program number is other than 1 to 9999. Modify the program number.

Fanuc Alarm 5118: SPL: ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description After manual intervention with manual absolute mode set to on, NURBS interpolation was restarted. Have you faced Fanuc Alarm 5118 SPL: ERROR on your machine? Share your experience or troubleshooting tips in the comments below to…

Fanuc Alarm 80: G37 ARRIVAL SIGNAL NOT ASSERTED Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description M series In the automatic tool length measurement function (G37), the measurement position reach signal (XAE, YAE,or ZAE) is not turned on within an area specified in parameter 6254 (value ε).This is due to a…