Fanuc Alarm 5412: NURBS:NO KNOT COMMAND

Fanuc Alarm 5452: IMPROPER G–CODE (5AXIS MODE) Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A G code that cannot be specified is found. (5–axis mode) This alarm is issued when;1) Three–dimensional cutter compensation (side–face offset and leading– edge offset) is applied during cutter compensation, or cutter compensation…

Fanuc Alarm 34: NO CIRC ALLOWED IN ST–UP /EXT BLK Fanus Control Model: Series 0i / 16i / 18i / 21i / 31i / 32i Description This alarm (Fanuc Alarm 34) occurs when you are starting (Start-up block) or ending (Cancel block) Cutter Radius Compensation using G41 or G42, and write Circular Interpolation (G02/G03) instead…

Fanuc Alarm 5213: SCREEN COPY: COMMUNICATION ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The memory card cannot be used. Check the memory card. (Check whether the memory card is write–protected or defective.) Have you faced Fanuc Alarm 5213 SCREEN COPY: COMMUNICATION ERROR on your machine? Share your…

Fanuc Alarm 85: COMMUNICATION ERROR Fanuc Control Model: Fanuc 0i-D/F, 16i/18i/21i, and 30i/31i/32i series Fanuc Alarm Description When entering data in the memory by using Reader / Puncher interface,an overrun, parity or framing error was generated. The number of bits of input data or setting of baud rate or specification No. of I/O unit is…

Fanuc Alarm 5425: ILLEGAL OFFSET VALUE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description The offset number is incorrect. Have you faced Fanuc Alarm 5425 ILLEGAL OFFSET VALUE on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear…

Fanuc Alarm 5059: RADIUS IS OUT OF RANGE Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A radius exceeding nine digits has been specified for circular interpolation with the center of the arc specified with I, J, and K. Have you faced Fanuc Alarm 5059 RADIUS IS OUT…