Fanuc Alarm 5302: ILLEGAL COMMAND IN G68 MODE

Fanuc Alarm 4505: ILLEGAL COMMAND IN GRID Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description In a grid (G78, G79) command, the number of holes (P, K) was set to zero or a negative value. Alternatively, I, J, K, or P was not specified. Have you faced Fanuc…

Fanuc Alarm 22: NO CIRCULAR RADIUS Fanus Control Model: 16/18/21 Fanuc Alarm Description When circular interpolation is specified, neither R (specifying an arc radius), nor I, J, and K (specifying the distance from a start point to the center) is specified.

Fanuc Alarm 5303: TOUCH PANEL ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A touch panel error occurred. Cause;1. The touch panel is kept pressed.;2. The touch panel was pressed when power was turned on. Remove the above causes, and turn on the power again. Have you…

Fanuc Alarm 233: DEVICE BUSY Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description When an attempt was made to use a unit such as that connected via the RS–232–C interface, other users were using it. Have you faced Fanuc Alarm 233 DEVICE BUSY on your machine? Share your experience…

Fanuc Alarm 1: TH PARITY ALARM Fanuc Control Model: Fanuc 0i, 16/18/21, 16i/18i/21i, 30i/31i/32i Fanuc Alarm 1 (TH Parity Alarm) is a Program / RS-232 Communication alarm that occurs when the CNC control detects an incorrect number of holes (odd/even parity error) while reading a tape or receiving a G-code program via serial communication. Follow…

Fanuc Alarm 5054: M–NET RECEIVE ERROR Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Polling time monitoring error (parameter No. 176) Have you faced Fanuc Alarm 5054 M–NET RECEIVE ERROR on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and…