Fanuc Alarm 5069: WHL–C:ILLEGA P–DATA

Fanuc Alarm 14: ILLEGAL LEAD COMMAND Fanuc Series 0i (0i-TC, 0i-TD, 0i-TF) Fanuc Series 16i / 18i / 21i Fanuc Series 30i / 31i / 32i Description The wrong feed rate and lead limit of the (Threading) process is higher or lower than the limit set in the program, or there is an error in…

Fanuc Alarm 5453: NOTE: G68 IS CANCELED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description When bit 2 of parameter No. 5400 is set to 1, and a reset does not cancel G68, this alarm is issued at the time of program restart. To release this alarm, press…

Fanuc Alarm 245: T–CODE NOT ALOWEE IN THIS BLOCK Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series;One of the G codes, G50, G10, and G04, which cannot be specified in the same block as a T code, was specified with a T code. Have you faced…

Fanuc Alarm 5251: ILLEGAL PARAMETER IN G54.2 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description A fixture offset parameter (No. 7580 to 7588) is illegal. Correct the parameter. Have you faced Fanuc Alarm 5251 ILLEGAL PARAMETER IN G54.2 on your machine? Share your experience or troubleshooting tips in the…

Fanuc Alarm 231: ILLEGAL FORMAT IN G10 OR L50 Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Any of the following errors occurred in the specified format at the programmable– parameter input.;1 Address N or R was not entered.;2 A number not specified for a parameter was entered.;3…

Fanuc Alarm 5413: NURBS:ILLEGAL AXIS COMMAND Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description An axis not specified with controlled points is specified in the first block. Have you faced Fanuc Alarm 5413 NURBS:ILLEGAL AXIS COMMAND on your machine? Share your experience or troubleshooting tips in the comments below…