Fanuc Alarm 5065: DIFFERENT AXIS UNIT (PMC AXIS)

Fanuc Alarm 245: T–CODE NOT ALOWEE IN THIS BLOCK Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description T series;One of the G codes, G50, G10, and G04, which cannot be specified in the same block as a T code, was specified with a T code. Have you faced…

Fanuc Alarm 95: P TYPE NOT ALLOWED (EXT OFS CHG) Fanuc Control Model: Series 0i (0i-A, 0i-B, 0i-C, 0i-D, 0i-F), 16 / 18 / 21 and their i-series variants (16i, 18i, 21i), 30i / 31i / 32i Fanuc Alarm Description P type cannot be specified when the program is restarted.(After the automatic operation was interrupted,…

Fanuc Alarm 5039: START UNREGISTERED B–AXS PROG Fanuc Control Model: 0i / 0i-Mate – Model B, 16 / 18 / 21 Fanuc Alarm Description T series An attempt was made to execute a program for the B–axis which had not been registered. Have you faced Fanuc Alarm 5039 START UNREGISTERED B–AXS PROG on your machine? Share…

A Fanuc Alarm 402 is a common but critical error that indicates a Servo Alarm: SV Overload. Essentially, the CNC controller has detected that the electrical current being drawn by a specific axis motor is exceeding its rated capacity for too long. The system triggers this alarm as a protective measure to prevent the motor…

Fanuc Alarm 240: BP/S ALARM Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description Background editing was performed during MDI operation Have you faced Fanuc Alarm 240 BP/S ALARM on your machine? Share your experience or troubleshooting tips in the comments below to help other CNC operators and programmers clear…

Fanuc Alarm 5245: OTHER AXIS ARE COMMANDED Fanuc Control Model: 16 / 18 / 21-Series, 16i/18i/21i and 30i/31i/32i series Fanuc Alarm Description One of the following command conditions was present during flexible synchronization or when flexible synchronization was turned on;1. The synchronous master axis or slave axis is the EGB axis.;2. The synchronous master axis…